Elevator UPS
An elevator or lift UPS falls under the category of offline UPS and consists of three main parts which are a charger, batteries and an inverter. A lift UPS takes three-phase supply and powers the elevator while charging the batteries at the same time. This electronic device can be better described as an effective power backup solution for elevators. An elevator UPS is manufactured by taking several important factors into consideration such as the duration of a common power cut, capacity of the lift motor, type of elevator, whether it would be used in a residential or commercial area, etc.
Feature:
- Smart CPU Control
- Support the lift in 7.5HP~47HP
- Small, Light & Easy to install
| MODEL | NV65AP-ARD-10 | NV65AP-ARD-15 | NV65AP-ARD-25 | NV65AP-ARD-35 | NV65AP-ARD-45 | NV65AP-ARD-60 |
|---|---|---|---|---|---|---|
| Capacity | 7.5HP | 11HP | 22HP | 35HP | 39HP | 47HP |
| AC Input | 415V / 220VAC + 15%-20% Three Phase Input. 50/60Hz ± 10% | |||||
| DC Voltage | 48Vdc / 60Vdc / 72Vdc / 96Vdc / 120Vdc / 144Vdc / 180Vdc | |||||
| Charger Type | Controlled Rectifier CVCC | |||||
| Charging Time | 10 Hours for 90% of Full Battery Capacity | |||||
| Inverter Technology | IGBT based PWM Sine Wave | |||||
| Inverter Output Voltage | 400V / 415V / 200Vac Three Phase 50/60Hz ±0.1Hz | |||||
| Inverter Efficiency | 85% | |||||
| Inverter Overload | 105% continuous | |||||
| Inverter Harmonic Distortion | ＜3% on Linear load | |||||
| Inverter Crest Factor | 4:1 | |||||
| Inverter Power Factor | 0.8 | |||||
| Inverter Phase Displacement | 120°±1° | |||||
| Dimension (L×W×D) | 530×400×195 mm | |||||
| LCD Display | AC normal;Inverter normal; Battery low and overload | |||||
| Protection | Output Overload and Short circuit & DC Under and Over Voltage | |||||
